ad
HOME Steel Sheet Piling ESC Steel WIDE U Profile EU3
prev
18ec40_88a2b16ee9394054aab536f89bd4fcac~mv2Screenshot_2
next
18ec40_88a2b16ee9394054aab536f89bd4fcac~mv2Screenshot_2

ESC Steel WIDE U Profile EU3

A wide profile pile utilising a robust ball joint clutch, the ESC-EU Series is efficient in terms of weight and installation costs. Suitable for temporary and permanent works. The profile is especially effective in marine conditions where strength and installation efficiency as premium considerations.

The advantages of EU sheet piles include:

  • Clutch provides annular area for effective joint sealing using sealants.

  • Interlocking clutches are located at the outer fibre.This results in an optimized section profile for high strength and low material weight.

  • High Moment of Inertia reducing deflection meeting serviceability requirements

  • Wider profile width reduces handling and installation time with usual driving equipment.

  • Wider profile reduces the number of interlocks required for a set wall run length, improving water-tightness capabilities.

Product Details

  • Section :

    ESC-EU3

  • Width :

    31.50 in
    800 mm

  • Height :

    6.73 in
    171 mm

  • Flange Thickness :

    0.226 in
    6 mm

  • Web Thickness :

    in
    mm

  • Single Pile Weight :

    30.84 lbs/ft
    45.9 kg/m

  • Wall Weight :

    11.74 psf
    57 kg/m²

  • Elastic Section Modulus :

    6.14 in³/ft
    330 cm³/m

  • Plastic Section Modulus :

    in³/ft
    cm³/m

  • Moment of Inertia :

    22.25 in⁴/ft
    3038 cm⁴/m

  • Cross Sectional Area :

    3.45 in²/ft
    73 cm²/m

  • Coating Area Both Sides :

    21.36 ft²/ft
    1.98 m²/m

  • Coating Area Wall Surface :

    ft²/ft²
    m²/m²

Bent Corners

bent info
  • The slotted pipe clutch can be orientated at any angle allowing almost any corner configuration, without requiring any wastage or additional welding. For internal corners a special piece can be fabricated with little cost due to the flexibility in the cold forming process. Note that the interlocks should be orientated toward the retained side as shown in the following figures.